Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Sample Configuration vor PRI (E1) and MICA Modem

Where can I find a Sample Configuration

for a Cisco 3640 with PRI (E1) and a

MICA Modem Card. (Has to work with Dialer Interface)

(I just found a Configuration for PRI (T1) and MICA Modem)

1 REPLY
Anonymous
N/A

Re: Sample Configuration vor PRI (E1) and MICA Modem

The configuratioj for a T1 or E1 is almost the same, except for E1 parameters:

controller E1 0

framing crc4

linecode hdb3

clock source line primary

pri-group timeslots 1-31

controller E1 1

framing crc4

linecode hdb3

clock source line secondary

pri-group timeslots 1-31

interface serial0:15

isdn incoming-voice modem

dialer rotary-group 1

!

interface serial1:15

isdn incoming-voice modem

dialer rotary-group 1

!

interface loopback0

ip address 172.16.254.254 255.255.255.0

!

interface ethernet0

ip address 172.16.1.1 255.255.255.0

!

!The following block of commands configures DDR for all the ISDN PRI interfaces

!configured above. The dialer-group and dialer rotary-group commands tie the

!interface configuration blocks to the DDR configuration.

!

interface dialer1

ip unnumbered loopback0

encapsulation ppp

peer default ip address pool default

ip local pool default 172.16.254.1 172.16.254.60

dialer in-band

dialer-group 1

dialer idle-timeout 3600

ppp multilink

ppp authentication chap pap default

221
Views
0
Helpful
1
Replies