Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Save Config

hi,

Can I save my config to a text file within a telnet session on my 2500 series router?

Thanks.

4 REPLIES
New Member

Re: Save Config

Yes you can........if you are using hypertermial, or most any other telnet application...just log the text to a file.....for ease of display before you show the running config, do a term length 0....this will scroll the entire config without having to have a pause....just don't forget to reset with a term len 24 command

New Member

Re: Save Config

Hi,

yes, you can - do show running on Your router and scrool through full configuration, then copy output You had and paste it into a text file, or turn on logging on terminal program and do show running again.

Hope that helps

Giedrius

New Member

Re: Save Config

Stephen:

You have a few options:

on enable mode (router#) you can do a write network and specify a tftp server address.

You can do a sh run and copy it from your terminal window.

You can use hyperterminal and log your session to a text file and then do a sh run. Close the session and then open the text file.

==DMT>

New Member

Re: Save Config

great - thanks for all the replies

129
Views
0
Helpful
4
Replies
CreatePlease login to create content