I am new to Cisco Networking so forgive the ignorance.
I have a 2600 router which I connect to using a console cable with one Ethernet interface configured. I have setup TFTP server and am able to copy config back and forth. I need to know when I am in the field and I need to copy a config using just the console cable is there a way to copy config using Xmodem on the Hyperterm like I would when updating the IOS through rmon mode or must I always have routing path available to a TFTP server to copy configs.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...