Recently I contacted an authoritative source regarding saving cisco catalyst 3550 switch configurations for a later use. The reason for doing this would be to replace a failed switch with its saved configurations. To do this we need to copy config.txt and vlan.dat separately to the new switch. I was wondering whether this all be combined into one running config file and upload to the switch for ease of use. Any insight would be greatly appreciated. Thanks.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...