For traffic monitoring we use Ngenius RTM. When i want to see the traffic usage of the core layer in bytes i see values over 8000000 bytes as a scientific number for instance :1E7 ect. Is there anyway i can see these calculations in bytes/s ? I have to run repports very often for our management and i don't think sientific calaculations will be easy for them :-)
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...