I have a Cisco 2620 router w/ IOS 12.0.3 that I use to connect our network to the internet via a T1. I have several users that use pcAnywhere for support purposes, but I only have two public IP addresses available. Currently, when I want to allow a user to send traffic over the pcAnywhere ports, I have to reconfigure the IOS to map their internal IP address to one of the public IP addresses. This is getting to be a lot of typing and I was wondering if their was a way to script this, so I could just change which internal address I want mapped to the public address and then run a script. This is all fairly new to me, so any suggestions would be appreciated.
Thanks,
Rick