This is for TLS connection to 2 remote sites using diffrent subnet, our setup is Hub and spoke. At Hub the link terminates on a Cat5500 Switch on a seperate Vlan and I have a Vlan interface configured for it on my RSM. What I intend to do is configure multiple Ip addresses on this Vlan interface for connnetivity to Switches at both Spoke Sites (I'm not using RSMs's at the Spoke Sites or Routers)
We use a seconday IP address on E0 so that 1 computer on our lan has a realworld IP address. I'm using an 827 with the 12.2(4)YA2 load.
ip address 126.96.36.199 255.255.255.252 secondary
ip address 192.168.1.1 255.255.255.0
I'm not 100% sure if a third or more IP's can be supported on 1 interface.
We do ours like this: Static IP for the router, and then I have a block of 4 routed to my static. Use on for the secondary E0 IP, and another for the comp itself and then just set the gateway of the comp to the secondary IP on the router.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...