I have problems with my 7500 ethernet,secondary ip is configured on this ethernet .the problem is whenever this router loses power it also lose the secondary ip and when the power is restored I have to reconfigure secondary ip everytime
is there any other way I can use to keep this secondary ip so that it doesn't get lost when the router goes off
secondary ip can be used to support a second or third (theoritically N) subnets on the same segment. Such scenarios appear, when u need to assign a public IP (which u get only a few in number from ISPs) to the lan segment, and also for the hosts in the lan segment, you will be using a private addressing scheme...say from the 10.x.x.x network...
Another scenario where u may need secondary network addr., is when u run out of ip addresses, on the lan segment, say u assign, 10.1.1.0/24 to your lan, and now u have more than 254 hosts..on the same lan..u can assign a second subnet 10.1.2.0/24 as secondary, on the same lan segment.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...