Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Selecting a multiservice/routing switches

I have got a requirement for a multiservice or routing switch. Im pasting it along with this meeage.Can anyone suggest me which switch touse and what all modules.

Thanks in advance

(MULTI SERVICE / ROUTING SWITCHES)

Interfaces to be supported:

100basetx fast Ethernet

Channelized E1 with g.703 coax interface

Serial port (x.21 ,v .35) for video

6 analog voice ports(FXS/FXO/E&M )

1 digital voice E1 port

The switch should have extension modules capability for optional addition of Ethernet or WAN interfaces

Frame relay

FRF 3.1 Multiprotocol encapsulation FRF 9 data compression for frame relay

Voice:

Must support voice over IP, voice over frame relay with:

CS-ACELp 8 kbps voice compression (g.729 and g729a) tandem voice switching silence suppression

Voice activity detection

Support for t.30 group 3 fax integrated echo cancellation

Integrated fax/modem detection

Protocol support:

TCP/IP suite

RIP1, RIP2, OSPF

VRRP

Point-to-point (PPP), HDLC multi link PPP

The switch should support load sharing on the WAN links

Quality of service support:

Layer 2/3/4 defined traffic flows capability

Qos should be supported on the MAN/WAN interfaces

Management requirements:

telnet

SNMP v1, SNMPv2

The software Managements for the ' switch should integrate with well known network Managements

platform (please identify in the remarks)

Out of band option

Rich logging feature internally with in the switch

Rich debug and diagnostic tools syslog server logging

RMON

RMON2

SNMP MIB II

Security options

Support for am

Support for RADIUS

Support for TACACS/TACACS+

Denial of service (dos) protection from TCP syn attacks and smurf

Minimum two level of access to the switch

Video:

Clear channel nx64k

Support for x.21 based video channel

Each remote site should have the following interfaces on delivery:

1 x 100 base tx Ethernet port --'- 2 x E1 g703 coax 75 ohms

1 x serial port (x.21 , v.35) for video

1 x e 1 voice module

1 REPLY

Re: Selecting a multiservice/routing switches

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

98
Views
0
Helpful
1
Replies
CreatePlease login to create content