I'm in the process of setting up BGP to a customer that is downstream from us. When asked if the customer wants BGP they said - yes - BGP with partial routes not full.
I know how to setup a BGP peering relationship but not sending partial routes. I'm assuming sending partial means that the upstream BGP peer would send large aggregate addresses instead of its ful BGP RIB.
Would anyone have helpful links on setting up BGP peers w/ partial routes?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...