Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Sending emails with NetConfig

I use NetConfig to send out config changes to my routers.

I select the option to send an email. I enter in three email address all seperated by a comma.

At job start and finish the only email sent out is the first email address entered and not the other two. I change the order of the email addresses, just to make sure I didn't enter incorrect email addresses, and I get the same thing. Only the first email address listed gets an email.

Am I doing something wrong??

Thanks.

2 REPLIES
Cisco Employee

Re: Sending emails with NetConfig

Have you tried name@xyz.com, name2@xyz.com ?

phil

New Member

Re: Sending emails with NetConfig

Yes. I opened a TAC case on this issue. In the end, I was told that NetConfig will only send to one email address.

88
Views
0
Helpful
2
Replies