Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

separate routing to WAN interaces for separate local ethernet interfaces

Hi, I currently have a 2621 with ISDN WIC and am in the process of upgrading to T1 service. I would like to put a WIC-1T in the other WIC slot and route trafic to that serial interface from the other Ethernet port. Basically I want all traffic from the FE0/0 to use Dialer1(ISDN) and all traffic from FE0/1 to use Serial0(T1) while I switch things over. On FE0/0 side we are using public IPs and on the new network FE0/1 I will be using private IP space so I will aslo be using NAT. IS this possible to have the router route traffic to a particular WIC based on which interface it comes from(like maybe with ACLs)? Anything special I need to know?

Thanks,

Mike

1 REPLY
New Member

Re: separate routing to WAN interaces for separate local etherne

229
Views
0
Helpful
1
Replies