Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Serial/Ethernet Interface

Please what do I do when i have the txload and rxload at increasing values such as 5 and over 5 for each of them?

Also when I get a deferred value on the Ethernet interface, what do I do to the router?.

If you could point me to the page that deals with what next to do when this values move from the norm and not just an explanatory page (explaining what each means), I will also be grateful.

Thanks

  • Other Network Infrastructure Subjects
2 REPLIES
Silver

Re: Serial/Ethernet Interface

Can you give more information as to what your question is about the tx/rxload. I do not understand what you are asking.

For half duplex Ethernet interfaces Deferrals are a normal function of the Carrier Sense function within Ethernet. If you are running Full duplex you should not see these.

See this link for the deferred explaination.

http://www.cisco.com/en/US/partner/tech/tk389/tk214/technologies_tech_note09186a008009446d.shtml

Hope this helps you,

Don

New Member

Re: Serial/Ethernet Interface

Thanks

82
Views
0
Helpful
2
Replies