Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Serial interface controller residual bit errors

We have an x21 serial interface connecting to a bpx frame-relay node.

The serial interface is amassing input and crc errors quite dramatically but we also notice that

on issuing command

#sh controller serial 0

the following output.

10241736 residual bit errors

(which is also incrementing)

Is this indicative of a card failure ??

1 REPLY
Anonymous
N/A

Re: Serial interface controller residual bit errors

It can be a defective connector, cable or backcard problem, try to isolate the problem by replacing each component one-by-one. Make sure the cable lenght is under X.21 physical specifications.

281
Views
0
Helpful
1
Replies