cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
580
Views
3
Helpful
10
Replies

Serial interface dont appears in my config

Hello,

I have two routers cisco1721 using IOS with IPSEC 3DES features. But, When i Check my serial interface, it dont apears in my config so i have WIC-1T card inteface.

What is the problem. The two routers are new.

Plz I need Help,

10 Replies 10

baileja
Level 1
Level 1

You do not have the correct IOS to support the WIC-1T. What image do you currently have, I can give you the name of the one you need if you give me the version you have and what your needs are.

Here is a link to check which IOS you need for the WIC-1T and the 1721. You just go to option two and select the drop down for WIC-1T.

http://www.cisco.com/pcgi-bin/finder/msbsearch.pl

lincolnp1
Level 1
Level 1

I've also noticed when you have configured virtual templates (used mainly for async routing) associated with serial int's, you do not see the serial configuration when a 'sh run' cmd is executed ...

hello,

alwyas the same problem. I attached a sh tech of my router plz check it and give me a feedback.

you will find all the information you need.

Best regards

Kheireddine

As I said before, your IOS. You must download a different version.

tblancha
Cisco Employee
Cisco Employee

For the 1721, the wic-1t is not supported in mainline 12.2 code but is in 12.2T. As per the HW/SW matrix, these are the minimum supported IOS levels for the wic-1t and 1721.

12.2(4)YA, 12.2(4)YB, 12.2(4)YH, 12.2(8)T, 12.2(8)YJ, 12.2(8)YL, 12.2(8)YM, 12.2(8)YN, 12.2(11)T, 12.2(11)YU, 12.2(11)YV, 12.2(13)T, 12.3(1)

Hello all,

Thanks for your help, now i use c1700-y-mz.122-4.YA2 IOS, i can see the serials (WIC-1T) but dont supprot IPSEC.

Now, i would use IPSEC 3DES in my router so it has only 32 mB Ram and 16 MB Flash.

Wich Release can i use in this case.

Plz Help me.

Kheireddine

Hello all,

My router has only 32Mb Ram and 16 Mb Flash.

Is there Release suppports IPSEC 3DES to use with my router.

Urgent

Best regards

Kheireddine

Unfortunatley you need a minimum of 48Mb of DRAM for all 1721 IPSec images that support the WIC-1T:

12.2T

File name Min. Memory(MB) Min. Flash(MB)

c1700-k9sy7-mz.122-15.T11.bin 48 16

12.2YA

File name Min. Memory(MB) Min. Flash(MB)

c1700-k9sy7-mz.122-4.YA6.bin 48 16

12.3

File name Min. Memory(MB) Min. Flash(MB)

c1700-advsecurityk9-mz.123-5b.bin 48 16

Hello all,

I thank all for your helps.

Now, i must upgrade my routers to 48Mb Ram.

Best regards

Kheireddine

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: