We have a Cisco 3700 Model router with 3 wic rj48. the service line is 6mb FR and is distributed through a widebank 28/adc path panel to the wics. we have had several various routers, standalone dsu's and combinations. the serial interfaces seem to always reset when the output queue is full and sporatically at night when no traffic at all. we have tried to test for grnd problems, line problems, etc. we have an identical setup in another location and it seldom fails, the only difference is that it is 9mb service line FR. no external problems are found on the bad site. any ideas?
The times i´ve seen the serials going to reset state, has been because of a bad framming issue conf. on the controllers ...are your controllers not showing you line code violations, path code violations or something??
As a workaround, give a no framing (CRC, NO CRC, ETC) and putting on it again...after thar shut/no shut the controller..it could helps you..
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...