Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

serial interface speed check

Hi,

does anybody know how to check the actual speed on a DTE serial port?

I've got my Cisco 1600 connected to a provider DCE which provides the clock.

I'd like to check that the speed is correct.

I think that sh controllers serial 0 should show the actual interface speed but the command output shows just some hex numbers and I haven't found any explanation on CCO.

Regards,

Milan

1 REPLY
Bronze

Re: serial interface speed check

Unfortunately there is no way to determine exactly what the speed a serial line is running at on a 1600.

The best you can do is to use the input and output byte counts for the last 5 minutes to see if they match the utilisation figure which is calculated using the configured bandwidth statement. If they match, then the bandwidth is correct.

248
Views
0
Helpful
1
Replies
CreatePlease to create content