I am setting an anlogue lease line. When i put encapuslation ppp my serial goes up then resets. i have configured the asyncronous , Physical -layer on my serial. When i change encasulation to slip the serial line goes up and line protocol up but the ping is not successful. advise.
I think you are missing some parameters. One of the most important parameter is in the line mode for the respective async interface. configure the follwoing while you have configured for encapsulation PPP.
Router(config)#modemcap entry default
router(config-line)#modem autoconfigure type default
dont mispell the word - default
And also check for any "PPP authentication chap" you have configured . If you have configured for PPP authentication , you have to configure the following on both the routers
router(config)#username xxxxx password xxxxx
Usually username is the hostname of the opposite router .
Use debug dialer and debug ppp negotiation commands to troubleshoot.
Also check the following URL and check for Router2 configuration for any parameters you are missing in your config. Dont check the Router1 configuration which will not be applicable for you.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...