06-23-2003 11:56 AM - edited 03-02-2019 08:21 AM
I'm getting a timeout error when testing the serial interface on a 2620 router.
This is the configuration on the serial interface.
wgc2600(config)#exit
wgc2600#show interface serial0/0
Serial0/0 is up, line protocol is up
Hardware is PQUICC with Fractional T1 CSU/DSU
Internet address is x.x.x.x
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 5/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 10 drops; input queue 0/75, 0 drops
5 minute input rate 34000 bits/sec, 17 packets/sec
5 minute output rate 6000 bits/sec, 11 packets/sec
2895596 packets input, 1117904702 bytes, 0 no buffer
Received 62751 broadcasts, 0 runts, 2 giants, 0 throttles
794 input errors, 151 CRC, 340 frame, 0 overrun, 0 ignored, 302 abort
2789957 packets output, 619468606 bytes, 0 underruns
0 output errors, 0 collisions, 22 interface resets
0 output buffer failures, 0 output buffers swapped out
3 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
Does anyone see anything wrong?
06-23-2003 12:12 PM
Cant say anything abt the counters, as the counters were never cleared. Clear the counters (clear counters s0/0 on privileged mode) and observe the counters, and revert back for further troubleshooting.
06-23-2003 01:41 PM
I did the clear counters command, but I'm still getting the failed test when I try to test the serial interface. "Timeout problem"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide