Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Server loadbalancing on Catalyst 4840g

I am trying to configure SLB on a 4840g switch any commands I type do not appear in the config and the sh ip slb ..... commands do not appear to exist has anyone seen this before ?

I am currently running IOS CAT4840g-i-mz.120-13.wt6.1a

2 REPLIES

Re: Server loadbalancing on Catalyst 4840g

Hi

Though the switch has reached EOS/EOL stage as per the command reference guie it does supports the commands related to SLB.

do refer this link for the same..

http://www.cisco.com/en/US/products/hw/switches/ps672/products_configuration_guide_chapter09186a008007f25c.html#1008734

have you already enabled or configured SLB related commands in your swtich ??

regds

New Member

Re: Server loadbalancing on Catalyst 4840g

Thanks for your reply.

Yes I have configured SLB related commands as per the config guide but these do not appear with a "show run" neither can you do a "show ip slb " the switch reports unrecognised command.

Regards

Dermot

126
Views
0
Helpful
2
Replies
CreatePlease login to create content