Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Set Boot System Flash Question

I get the following on a module of our 6513 switch:

#set boot command

set boot config-register 0x2102

set boot system flash bootflash:

set boot system flash bootflash:cat6000-sup720cvk8.8-4-2a.bin

!

Why is the first one empty? How can I resolve that?

  • Other Network Infrastructure Subjects
1 REPLY

Re: Set Boot System Flash Question

Hi,

You need to remove the first boot statement from the config for the switch to boot from the image as intended by you.

Here's how you clear the incorrect boot statment.

SW3-6509 (enable) clear boot system flash bootflash:

Hope that helps!

Regards,

Sundar

360
Views
0
Helpful
1
Replies