Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Set cam support on 2948G

Does the basic IP code on the 2948G-L3 support static entries in the CAM table? The command "set" does not appear to exist in config mode. If it is not supported, is it supported in the Advanced IP verion of the code

FR2948GL3-IP?

Peter

1 REPLY
New Member

Re: Set cam support on 2948G

Try the following syntax:

mac-address-table static mac_addr

{vlan vlan_id} {interface int1 [int2 ... int15

75
Views
0
Helpful
1
Replies