Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

'set ip next-hop' documentation [PBR w/ route-map]

First of all, excuse for posting a second thread to this forum, which is very related to another conversation I started some days ago.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.eea0c57

As I still haven't been able to fully clarify my doubts expressed there, I would like to know if (meanwhile) someone could point me in the right direction for specific documentation about the 'set ip next-hop' command in route-map configuration mode.

I already searched and read plenty of stuff on the Cisco website, but it was all very vague concerning things like 'set ip next-hop', failover options, etc... For instance, the IOS command references and "Configuring Policy-Based Routing" lack much detail about all the parameters and how they work together.

Thanks a lot,

/dima

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: 'set ip next-hop' documentation [PBR w/ route-map]

The command reference for the command can be found below:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/iprrp_r/ip2_s1g.

2 REPLIES
Silver

Re: 'set ip next-hop' documentation [PBR w/ route-map]

The command reference for the command can be found below:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/iprrp_r/ip2_s1g.

New Member

Re: 'set ip next-hop' documentation [PBR w/ route-map]

Hello:

Thanks for you reply... Actually you left off the '.htm' extension in the URL you provided, so the correct address is the following:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/iprrp_r/ip2_s1g.htm

Anyway, I already read *a couple* of command references about 'set ip next-hop', but I don't have the impression of already having read this particular page... humm, strange! Although I found this reference helpful, it still lacks some detail (or presumes better knowledge of Cisco routing internals than mine :-)

By the way, I have also solved my other issue referred in the first message of this conversation (19 September). For whomever might need it check it out...

/dima

321
Views
0
Helpful
2
Replies
This widget could not be displayed.