Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

set port <mod/prt> debounce - ?

Does anyone know what function is the "set port <mod/prt> debounce" command used for?

1 REPLY
Community Member

Re: set port <mod/prt> debounce - ?

The debounce timer is the time a module's firmware waits before notifying the Supervisor Engine of a link change at the physical layer when a link goes down. This feature allows a user to enable an Ethernet Link Debounce timer on a per-port basis on Ethernet blades.

342
Views
0
Helpful
1
Replies
CreatePlease to create content