Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SetTemperature Threshold

Hi,

is it possible to set the Temperature Threshold

on Catalyst 2948 by user ?

Thanks,

Peter

2 REPLIES
Silver

Re: SetTemperature Threshold

The temperature threshold is generally 40C. Unfortunately, there is no way to configure that to be a different temperature. Use the show environment temp to see the temperature settings . For the 2948, the Temperature, ambient operating is 320F (00C) to 1040F (400C) Temperature, ambient nonoperating and storage is -400F (-400C) to 1670F (750C)

New Member

Re: SetTemperature Threshold

Does the high-temperature alarm at 40 deg C actually shut the switch down?

The only reference I found to the operating range of Catalyst stackable switches was:

http://www.cisco.com/en/US/products/hw/switches/ps646/products_installation_guide_chapter09186a008011b582.html

It would be nice if we actually had the ability with these Catalyst switches to see the current temperature. Perhaps the temperature is measured not with an actual sensor but with some crude temperature measurement tool?

-Steve

162
Views
0
Helpful
2
Replies
CreatePlease to create content