Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Setting a lab 7206 to facory defaults

Is there a way to reset a 7206 router to factory defaults so that the startup-config. and run-config. has been set back like it was when the router was taken out of the box beside typing the no command for each line of the running-configuration and then coppying it to the startup-configuration?

Thanks,

DTA

2 REPLIES
Community Member

Re: Setting a lab 7206 to facory defaults

there are hardly any setting on it when you first receive the 7200 router. so if you really wants to do this, you may as well write erase, and type setup start all over.

Community Member

Re: Setting a lab 7206 to facory defaults

Very simple:

write erase

reload

Do NOT save the configuration if it prompts you to.

Mick.

636
Views
0
Helpful
2
Replies
CreatePlease to create content