I am trying to set the duplex setting to "auto" on a port on Cat-2950 switch. The port speed is 100. I am using CLI and getting an error message that a port duplex could only be set to "half" or "full". Yet, the doc states that the "auto" is an allowable setting.
You can't hardcode the speed to 100 and set the duplex to auto , it has to be either auto/auto or 100/full or 100/half hardcoded . Also remember to exactly match whatever is going to be on the other end of this interface whether it be a workstation or another switch .
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...