cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
241
Views
0
Helpful
1
Replies

Setting runtime trust to trusted

dyoungs
Level 1
Level 1

Although port is set as follows:

set port qos 6/5,6/27 trust trust-cos

the sh qos info run 6/5 suggests that the runtime trust is actually untrusted:

The qos trust type is set to trust-cos.

Warning: Runtime trust type set to untrusted.

Do I need to set the runtime trust to trusted and if so how?

1 Reply 1

didyap
Level 6
Level 6

The runtime status will be untrusted even if you configure trust-cos on the port and on the acl mapped to the port. This is because the ACL applies to the traffic not the port. You could refer to the following doc for details.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_7_1/conf_gd/qos.htm

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: