Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setting up 2 6506 as primary and 2ndary

Hello,

I have 2 6506 chassis with FlexWAN module and each FlexWAN blade has PA-4T1 modules.

I have 8 T1s coming from ISP-A(4) and ISP-b(4). 4 T1s from same ISP, are connected to same PA-4T1 module via MFR on 6506-A. The other 4s are connected to other PA-4T1 on 6506-B as the same way.

I wonder if I can split each ISP's T1s into 2 groups and have them connected to each PA-4T1 module.

X2(1/2) ISP-A + X2(1/2) ISP-B => 6506 - A

X2(3/4) ISP-A + X2(3/4) ISP-B => 6506 - B

My goal is to keep 50% of each WAN link in case one of switch failed.

Is this possible?

1 REPLY

Re: Setting up 2 6506 as primary and 2ndary

Hi

I feel you can try out configured Multichasis Multilink for your requirement.

Similar kinda scenario is discussed in this url which talks about MMP.

http://www.cisco.com/en/US/tech/tk713/tk507/technologies_tech_note09186a008009408f.shtml

regds

98
Views
0
Helpful
1
Replies
CreatePlease login to create content