Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setting up Port Grouping in a 2900XL Switch Cluster

My question is this..

Should I setup the port-groups on the "command" switch or should I setup up the port-groups on each of the "member" switches? (we have 2 "member's")

Does it matter?

Cisco says since I'm connecting switches I should use the (Default) Forwarding based on Destination-address. Any help?

Thanks.

1 REPLY
New Member

Re: Setting up Port Grouping in a 2900XL Switch Cluster

It’s hard to say without seeing your topology, but I would follow Cisco’s advice. Here are some documents you may want to look at:

http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35xu/scg/kiconfig.htm

97
Views
0
Helpful
1
Replies
CreatePlease login to create content