Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setting up RAS on Cisco 2600

I'm looking to setup a RAS server on my Internet 2600 router that is outside of my firewall for 2 or three dial-up users. One they've gone through the dial-up authentication then they would go through a VPN 3005.

I'm having a hard time finding information on some basic help setting up the RAS. I think I'll be getting a 2-port modem WIC but no external authentication servers.

Thanks for any help.

1 REPLY
New Member

Re: Setting up RAS on Cisco 2600

aaa authentication ppp default if-needed local

username USER password PWD

isdn switch-type YOUR-COUNTRY

interface Dialer1

ip unnumbered FastEthernet0/0

no ip directed-broadcast

encapsulation ppp

no ip mroute-cache

dialer in-band

dialer-group 1

peer default ip address pool POOL

no fair-queue

no cdp enable

ppp authentication pap

Bind this logical interface to any physical (bri, pri, ...), for example with dialer rotary-group 1.

Or, if you have async connection, you can use

interface Group-Async1

ip unnumbered FastEthernet0/0

no ip directed-broadcast

encapsulation ppp

dialer in-band

dialer idle-timeout 600

dialer-group 1

async mode interactive

peer default ip address pool POOL

no cdp enable

ppp authentication pap

group-range 65 76

where 65 76 are your modems

ip local pool POOL 192.168.0.1 192.168.0.10

and this if you have mica modems

line 65 76

session-timeout 10

timeout login response 80

autoselect during-login

autoselect ppp

absolute-timeout 180

modem InOut

modem autoconfigure type mica

autocommand ppp

transport input all

flowcontrol hardware

if you have an ISDN interface and modems, you need to configure dialer and groupasync

bye

106
Views
0
Helpful
1
Replies
CreatePlease login to create content