I am setting up a WAN link to a remote office via a BT 2Mbps serial link. Both ends will be using a 1721 router with a X.21 WIC for the connection and a Fast Ethernet connection into the network at each end. I have given an IP address to fastethernet port of the router at the main site end within the same subnet as the main site's addressing scheme, the remote site has a different subnet (obviously!) From what I gather, I do not need to assign an IP address to either of the serial ports on each of the routers. Firstly, is this correct, secondly have I missed anything.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...