Im having a weird problem; in my Active LAN Im having Switch Fabric Module [SFM] installed in the Catalyst 6513 Core Switch, the 1st time I found the problem was while doing my daily healthy check I found that the SFM as if its switched off, and after showing the results of the diagnostic tests for the SFM module I figured out that it was a hardware failure in the module I went through the RMA procedures and I got another SFM from my spare parts and I installed it again instead of the faulty one and early this morning and after almost 10 days from using the new SFM I found another problem the core switch was reloading every 1minute and all the modules installed on it are showing fatal error then the switch reset the modules to be in a disabled state.. So I unplugged the SFM and then every thing went back normal again.. Knowing that Im having another 6513 catalyst core switch with the same modules installed in the same places with the same configurations with the same IOS image but till now there is no problem at all..
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...