I've 2 Cisco 3640 with one E1 PRI in each one, these routers are running HSRP and tracking E1 PRI , behind these routers there is a firewall that sends packets to ip active, if one E1 fails then HSRP selects the other router as active router .
Actually I have 29 remote users but shortly they will be 40 users and then PRI will be full .
When the PRI is full , new calls to this full PRI are redirected to the second PRI but my firewall will be sending packets to the HSRP group active (router with PRI full) and the new calls will fail.
How can I solve this problem? Is multichassis multilink /SGBP a solution for it?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...