Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

sh fr pvc command - output results

S1 was in an UP/DOWN state and S1.2 was in a DOWN/DOWN state. When I executed the "sh fr pvc" command after AT&T rebuilt my pvc, I noticed that the "last pvc status change" field reflected the config change from AT&T (2min 45 sec.). However, the "PVC create time" field still showed to be at 32 weeks. Should this field also change to reflect the rebuilt PVC on S1.2????

2 REPLIES
Silver

Re: sh fr pvc command - output results

Depending on what they changed on the PVC the creation time would not be updated. If CIR or other mapping changed, other than deleting and recreating the pvc this creation time will not be updated.

Hope this helps,

Don

New Member

Re: sh fr pvc command - output results

Thanks for the input Don. Actually, they did delete and re-create the PVC but the create time did not change. Werid or just a bad serial port?

98
Views
3
Helpful
2
Replies