Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sh int fa0/43 shows "interface resets"

Hi,

I would appreciate if someone can help to advise what does it mean by "interface resets" when sh int fa0/43 is entered in the prompt. I encountered 2 interface resets(below is the output), what is the cause of it?

Please advise.

Thanks

christina

C2950#sh int fa0/43

FastEthernet0/43 is up, line protocol is up (connected)

Hardware is Fast Ethernet, address is 000d.5e11.4e2b (bia 000d.5e11.4e2b)

MTU 1500 bytes, BW 100000 Kbit, DLY 1000 usec,

reliability 255/255, txload 7/255, rxload 2/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 100Mb/s

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output 00:00:00, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 933000 bits/sec, 149 packets/sec

5 minute output rate 2981000 bits/sec, 263 packets/sec

2819781393 packets input, 3782332886 bytes, 0 no buffer

Received 266693 broadcasts (0 multicast)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 0 multicast, 0 pause input

0 input packets with dribble condition detected

4015025747 packets output, 2328228393 bytes, 0 underruns

0 output errors, 0 collisions, 2 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 PAUSE output

0 output buffer failures, 0 output buffers swapped out

C2950#

1 REPLY
New Member

Re: sh int fa0/43 shows "interface resets"

Hi,

Interface resets means - no. of times the interface has been completely resetted.There can be several reasons for it like - if interface is physically down and came back up then it will show reset counter as 2.Or if somebody shut down the interface from switch prompt and then no shut it then it will show reset counters as 2.Is this interface participating in HSRP or not.I can't see errors on the interface though so we can rule out any media error.

Kindly let me know if it helps and rate this post if it does.

cheers

Sachin

3121
Views
7
Helpful
1
Replies
CreatePlease to create content