Hello guys,
Need your ideas on how to know to which port a device connected to using mac-address information on Cisco DLSw RSP4.
I did tried using command "sh mac-address add" but it is not recognized in this IOS.
See below outputs:
RSP-Core#sh ver
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-DSV-M), Version 12.1(13), RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Wed 30-Jan-02 13:58 by kellythw
Image text-base: 0x60010958, data-base: 0x61186000
.....
cisco RSP4 (R5000) processor with 131072K/2072K bytes of memory. >>>>>>>>>
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
RSP-Core>sh ip arp tok 1/1/0
Protocol Address Age (min) Hardware Addr Type Interface
Internet 146.X.3.76 5 0060.9435.63e2 SNAP TokenRing1/1/0
Internet 146.X.3.77 5 4000.2030.2410 SNAP TokenRing1/1/0
RSP-Core#sh mac-address add ?
% Unrecognized command
RSP-Core#sh mac-