I was setup an 1700 cisco (ios 12.1) about several Subnets in my network to be able use Burst bandwidth. I would like to share equael or specific rate to each them ( per IP or per subnet ) when the traffic congestion. Then If traffic no congestion each Subnet could be burst speed to specific of Bandwidth speed.
My rouer (cisco 1700 iso 12.1(T)) haven't rate-limit command. I could share unallocated bandwidth to my subnets by policy-map command. but now i want to know how i could put a limitation on max bandwidth for subnets.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...