Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

should the switches be adjacent for them to use VTP?

In order for the network to use VTP,must the Catalyst switches be adjacent to each other?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: should the switches be adjacent for them to use VTP?

No the switches do not need to be adjacent to each other. They just need to have the same common Management VLAN between them (Same subnet). The VTP protocol is a layer 2 protocol and stops once it sees a layer 3 interface.

1 REPLY
Silver

Re: should the switches be adjacent for them to use VTP?

No the switches do not need to be adjacent to each other. They just need to have the same common Management VLAN between them (Same subnet). The VTP protocol is a layer 2 protocol and stops once it sees a layer 3 interface.

94
Views
0
Helpful
1
Replies
CreatePlease to create content