Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show installed cards

I have a 7206vxr and don't know what command, if any, will display the make and model of cards we have installed in the router.

I'm working on a script that telnets into the router, runs command abc - and from that, easily see what cards are where.

A 'show version' only shows what interfaces are available, showing the running-config shows what interfaces are in what slot - however both of these aren't specific enough.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: show installed cards

Try the "show diag" command. It reports on the card in each slot. Here is a link to the command description:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/ffun_r/ffrprt3/frf013.htm#1020428

HTH

Mark

1 REPLY
Bronze

Re: show installed cards

Try the "show diag" command. It reports on the card in each slot. Here is a link to the command description:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/ffun_r/ffrprt3/frf013.htm#1020428

HTH

Mark

5204
Views
0
Helpful
1
Replies