Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Show Interface - What is M4T Hardware Type?

I have a remote router which gives the following output when I do a show int.

I would like to clarify what the M4T Hardware Type is (i.e. Cisco part number etc) as I need to understand what speeds it can support.

#show int s3/1

Serial3/1 is up, line protocol is up

Hardware is M4T

Description:

MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,

reliability 255/255, txload 23/255, rxload 73/255

Encapsulation PPP, crc 16, loopback not set

Keepalive set (10 sec)

LCP Open, multilink Open

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 2d05h

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 37000 bits/sec, 71 packets/sec

5 minute output rate 12000 bits/sec, 62 packets/sec

3999236 packets input, 272171722 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

74 input errors, 68 CRC, 0 frame, 0 overrun, 0 ignored, 6 abort

4249991 packets output, 429401522 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions DCD=up DSR=up DTR=up RTS=up CTS=up

#

  • Other Network Infrastructure Subjects
2 REPLIES
Cisco Employee

Re: Show Interface - What is M4T Hardware Type?

I suppose this is a 7200 router. In that case, M4T should correspond to a PA-4T+.

New Member

Re: Show Interface - What is M4T Hardware Type?

do a "show run" the slot number is the first number second is the port so if you have a four port card it will look something like this:

interface Serial0/0

bandwidth 1544

ip address 10.0.0.0 255. x.x.x.x

ip nat outside

interface Serial0/1

no ip address

shutdown

!

interface Serial0/2

no ip address

shutdown

!

interface Serial0/3

no ip address

shutdown

Also a sh ver may help you :

cisco 3640 (R4700) processor (revision 0x00) with 125952K/5120K bytes of memory.

Processor board ID 22027819

R4700 CPU at 100Mhz, Implementation 33, Rev 1.0

Bridging software.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp).

TN3270 Emulation software.

Basic Rate ISDN software, Version 1.1.

2 FastEthernet/IEEE 802.3 interface(s)

4 Serial network interface(s)

8 ISDN Basic Rate interface(s)

Integrated NT1's for 8 ISDN Basic Rate interfaces

DRAM configuration is 64 bits wide with parity disabled.

125K bytes of non-volatile configuration memory.

Good luck.

1329
Views
0
Helpful
2
Replies