When you do a Show IP interface brief command on a router and you get STATUS reset and PROTOCOL down on a Serial0/0:0. What does the RESET mean. I have always come across either UP/UP; Down/Down or UP/Down. Never come across Reset/Down. How do I get rid of this. I have tried to clear the interface but still does not work.
I hope you are using a channelised E1 for this connection. If all the channelised interfaces are showing RESET, give a "show controllers e1" and see if it is showing up.Check the framing (CRC4) and line code too.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.