Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show ip protocol

hi pros,

below is an extract of the above cmd;

Routing Protocol is "rip"

Sending updates every 30 seconds, next due in 20 seconds

Invalid after 180 seconds, hold down 180, flushed after 240

Outgoing update filter list for all interfaces is not set

Incoming update filter list for all interfaces is not set

Redistributing: rip

Default version control: send version 2, receive version 2

Interface Send Recv Triggered RIP Key-chain

Ethernet0 2 2

Ethernet1 2 2

Serial0 2 2 housekey

Automatic network summarization is in effect

Maximum path: 4

Routing for Networks:

10.0.0.0

172.31.0.0

Routing Information Sources:

Gateway Distance Last Update

172.31.11.1 120 00:00:01

172.31.13.1 120 00:42:40

Distance: (default is 120)

When the gateway for 'Routing Information Sources' is dead, it doesnt get removed/discard.

Must i remove it manually?how?

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: show ip protocol

Kelvin,

That is simply an informational line. The fact that the router remembers that you heard from a gateway 42 minutes ago is simply for your information. It does not impact on RIP operation at all.

If you really want to clear it, you will have to remove the rip process and then re-configure it but I don't see any reason why you need to do so.

I would appreciate you rating the post if it helps.

Paresh

1 REPLY
Purple

Re: show ip protocol

Kelvin,

That is simply an informational line. The fact that the router remembers that you heard from a gateway 42 minutes ago is simply for your information. It does not impact on RIP operation at all.

If you really want to clear it, you will have to remove the rip process and then re-configure it but I don't see any reason why you need to do so.

I would appreciate you rating the post if it helps.

Paresh

285
Views
0
Helpful
1
Replies
CreatePlease login to create content