Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Show standby command

Hi,

When i monitor the "Show standby " command output---

Local state is Init (interface down)

I have shutdown the interface manually to check the hsrp fucntion,could be administratively down.Any idea would be appreciated.

Thanks

1 REPLY
Cisco Employee

Re: Show standby command

Instead of using "shutdown" command which will bring the interface administratively down, try to unplug the cable from that port. That will put the serial interface in down/down mode or change the encap to make it in up/down mode and see what "sh standby" reports. I think that is the right way to test it.

234
Views
0
Helpful
1
Replies
CreatePlease to create content