Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Cisco Employee

Shutdown more than 1 interface with a command

Hi All,

What is the IOS command in the 4506 to shutdown or enable more that one port with a single command?

I do not want to go into each interface configuration and give "shutdown command" for each port!

Thanks

Matteo

1 REPLY
Cisco Employee

Re: Shutdown more than 1 interface with a command

You can use the interface range command

Here is an example from my lab switch

Switch#sh mod

Mod Ports Card Type Model Serial No.

----+-----+--------------------------------------+-----------------+-----------

1 2 1000BaseX (GBIC) Supervisor(active) WS-X4515 JAB062408TV

4 48 10/100BaseTX (RJ45) WS-X4148 JAB031108W1

M MAC addresses Hw Fw Sw Status

--+--------------------------------+---+------------+----------------+---------

1 000a.4173.f540 to 000a.4173.f541 0.4 12.1(12r)EW( 12.1(13)EW1, EAR Ok

4 0050.547b.0a30 to 0050.547b.0a5f 1.5 Ok

Switch#conf term

Enter configuration commands, one per line. End with CNTL/Z.

Switch(config)#interface range ?

FastEthernet FastEthernet IEEE 802.3

GigabitEthernet GigabitEthernet IEEE 802.3z

Port-channel Ethernet Channel of interfaces

Vlan Catalyst Vlans

macro macro keyword

Switch(config)#interface range fastethernet 4/1 - 48

Switch(config-if-range)#shut

Switch(config-if-range)#no shut

Switch(config-if-range)#end

Switch#wr

Building configuration...

Compressed configuration from 2090 bytes to 854 bytes[OK]

Switch#

185
Views
0
Helpful
1
Replies