Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Simple 2620/IOS question

I have a Cisco 2620 (non-xm) router. I would like to use the “ip dhcp client client-id” command. Is it possible to get “12.3(2)XF” on my 2620. Is that part of 12.3 nainline? If so please confirm flash memory requirements for base IP feature set.

Appreciate

1 REPLY
New Member

Re: Simple 2620/IOS question

I just checked CCO and don't see a 12.3(2)XF for the 2620 (non XM) platform. Are you sure that's the rev you need?

As of this a.m. 12.3.6a *is* available which is mainline code for your box. I didn't look in the release notes to see if the specific command you're looking for is there but that image will require minimum of 8mb of flash and 32mb of DRAM

Good luck.

90
Views
0
Helpful
1
Replies
CreatePlease to create content