Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Simulate T1 WAN connection

I have two 2600's. What cables do I need to simlate a T1 connection?. they both have T1 interfaces.

thanks

3 REPLIES
New Member

Re: Simulate T1 WAN connection

You need a x-over T-1 cable, set one the CSU/DSU's clock to "internal" and specify "clock-rate" on one of the router so the line protocol comes up.

Here's the pin-out for the cable:

1 4

2 5

4 1

5 2

Good luck!

New Member

Re: Simulate T1 WAN connection

thanks guys!... i'll give that a shot!

New Member

Re: Simulate T1 WAN connection

All you need to to is get a T1 Cross Over cable. Once you assign IP's to all necessary interfaces, you can test connectivity...

Here are the pinouts for the cable:

Pinout:

1 --> 5

2 --> 4

4 --> 2

5 --> 1

548
Views
0
Helpful
3
Replies