I would like to become better at configuring frame-relay on cisco routers, however I have no frame-relay wan connection to use.. I was wondering if it is possible to simulate frame-relay from one router, and then configure it on the other.. kinda like in a back-to-back environment.
If it is possible, what would I need - and where could I find more information about this topic.
I think you need at least 3 routers to get the purpose, one router works as the frame-relay switch and the other two are connected with the frame-relay switch respectively. You need two serial ports on the switch.
On the switch, you need configure it as a real FR switch, something like this:
no ip address
no ip directed-broadcast
no ip mroute-cache
frame-relay intf-type dce
frame-relay route xyz interface Serial1/1 zyx
on the two routers, you can try to practice frame-relay by use frame-relay map command.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.