Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Sinec h1 protocol (Industrial Ethernet) on Catalyst Switches?

Hi,

I have an Industrial client who want to replace their optical hubs with switches. They have an fibre backbone and run ethernet over fibre to the PC's.

However they also run process control electronics using Siemens SINEC H1 protocol.

Does anyone know if Cat switches can support this protocol and if so is any special config or Cat OS required?

Regards,

Martin

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions

Re: Sinec h1 protocol (Industrial Ethernet) on Catalyst Switches

The Siemens SINEC H1 protocol is a ISO OSI layer 4 protocol. It runns over the ethernet data link layer, so no configuration is required for catalyst switches.

Cheers,

Liviu

2 REPLIES

Re: Sinec h1 protocol (Industrial Ethernet) on Catalyst Switches

The Siemens SINEC H1 protocol is a ISO OSI layer 4 protocol. It runns over the ethernet data link layer, so no configuration is required for catalyst switches.

Cheers,

Liviu

New Member

Re: Sinec h1 protocol (Industrial Ethernet) on Catalyst Switches

Thank you!

808
Views
0
Helpful
2
Replies
This widget could not be displayed.