i have a PRI connected to a PBX and noticed the slip secs increasing i have already tried changing the cable length and the clock source as stated in the documnet below and found no resolution. Any suggestions
You will need the assistance of your provider to determine why the line clock is not synchronizing. Verify with your provider if the clock configuration under the controller matches what is provisioned on the line.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...